Product information
World Champion software. The software is based largely on that of the GM SX12 controller, which won the World Championships in 2004. The integral micro-controller automatically detects the connected motor type from the motor wiring arrangement. Brushless motor. Brushed motor for models with reverse function (2/3 continuous load capacity, max. 9.6 V operating voltage). Brushed motor for models without reverse function (double continuous current capacity). Start-up protection function if stick is in wrong position when switched on. The controller is not armed until the stick is moved to the »motor off« or »brake« position.
SET button:
Numerous supplementary functions can also be programmed simply using the GMVIS Commander, PC RS232 interface or SET button:
Rotational speed limit (brushless motors only)
Timing: 0°, 7,5°, 15° or 30° (brushless motors only)
Soft-start
Current limiting
Current rise function at full-throttle
Brake minimum
Brake maximum
Start-up current limiting
Automatic brake
Frequency mode
Power curve (soft, linear, hard)
Automatic throttle
Full brake
Maximum reverse speed
Switched functions
ABS brake function
Mode:
Mode 1: Electric-powered model gliders, all models (forward with EMF brake), factory default setting
Mode 2: All models without brake and without reverse function (power model aircraft, model boats)
Mode 3: Model helicopters with speed regulation (governor moode)
Mode 4: Models with brake and reverse function (model car, model boat)
Specification
Operating voltage range 7.2 ... 14.8V (19.2V*)
Cell count, Ni-Cd, Ni-MH 6 to 12 (16*)
Cell count, Li-Po, Li-Io 2 to 4 (5*)
Cont. current (brushless motors) 70 A
Maximum motor current (10 sec.) 140 A
Temperature cut-off approx. 120° C
EMF brake programmable
Reverse function programmable
Soft-start programmable
Low-voltage power-down yes
Power-on pulse suppression yes
Pulse frequency 8 kHz
BEC receiver power supply approx. 5.5 V / 4 A peak
Max. BEC dissipated power at 20° C 2.5 W
OPTO optional
Dimensions excl. capacitors approx. 50 x 27 x 15 mm
Dimensions incl. capacitors. approx. 70 x 27 x 15 mm
Weight excl. cables approx. 33 g
Weight incl. cables approx. 70 g
Replacement for Order No. 94133
* with opto-coupler, Order No. 2894.3, and when using a four-cell receiver battery
| 
